石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

Inorganic iodine incorporation into soil organic matter: evidence from iodine K-edge X-ray absorption near-edge structure

The transformation of inorganic iodine (I⁻ and IO₃⁻) incubated in soils with varying amounts of organic matter (Andosols from the surface layer of an upland field and forest, as well as Acrisols from surface and subsurface layers of an upland field) was investigated by using the iodine K-edge X-ray absorption near-edge structure (XANES). After 60 d of reaction, both I⁻ and IO₃⁻ were transformed into organoiodine in surface soils containing sufficient amounts of organic matter, whereas IO₃⁻ remained unchanged in the subsurface soil of Acrisols with low organic matter contents. Transformation of IO₃⁻ into organoiodine was not retarded when the microbial activity in soil was reduced by γ-ray irradiation, suggesting that microbial activity was not essential for the transformation of inorganic iodine into organoiodine. Soil organic matter has the ability to transform inorganic iodine into organoiodine.     

正交试验-硝酸微波消解-冷原子吸收法测定土壤中汞

应用硝酸微波消解土壤样品-冷原子吸收法测定土壤中的汞。通过正交试验，优化了土壤中汞的微波消解条件。并对干扰消除、方法精密度、加标回收、检出限进行了试验研究。在0～10μg／L范围内线性关系良好，方法测定下限为0．20μg／L，土壤中汞的检出限为0．005μg／g。该优化条件对汞含量为0．02—0．46μg／g的土壤样品，汞提取完全。建立了一种简便、成本低、干扰少、灵敏度高的方法。     

垃圾焚烧炉炉膛温度的影响因素

垃圾焚烧过程的不稳定会导致大量有害物质的生成,为确保垃圾的清洁燃烧需要将炉膛温度控制在850℃以上,为此测试了焚烧炉运行的主要可控参数对炉膛温度的影响。结果表明,垃圾堆放位置在垃圾池深3～8 m处,并经过6 d以上发酵脱水后适合焚烧;炉膛温度随给料量、一次风率和一次风温增加而增大,随过量空气系数增加而降低,其中给料量宜控制在95%～110%之间;当过量空气系数为1.6、一次风率为90%、一次风温为260℃、给料量为100%时炉膛温度达901℃。     

The structure of the fire fighting foam surfactant Forafac®1157 and its biological and photolytic transformation products

For several decades, perfluorooctane sulfonate (PFOS) has widely been used as a fluorinated surfactant in aqueous film forming foams used as hydrocarbon fuel fire extinguishers. Due to concerns regarding its environmental persistence and toxicological effects, PFOS has recently been replaced by novel fluorinated surfactants such as Forafac®1157, developed by the DuPont company. The major component of Forafac®1157 is a 6:2 fluorotelomer sulfonamide alkylbetaine (6:2 FTAB), and a link between the trade name and the exact chemical structure is presented here to the scientific community for the first time. In the present work, the structure of the 6:2 FTAB was elucidated by ¹H, ¹³C and ¹⁹F nuclear magnetic resonance spectroscopy and high-resolution mass spectrometry. Moreover, its major metabolites from blue mussel (Mytilus edulis) and turbot (Scophthalmus maximus) and its photolytic transformation products were identified. Contrary to what has earlier been observed for PFOS, the 6:2 FTAB was extensively metabolized by blue mussel and turbot exposed to Forafac®1157. The major metabolite was a deacetylated betaine species, from which mono- and di-demethylated metabolites also were formed. Another abundant metabolite was the 6:2 fluorotelomer sulfonamide. In another experiment, Forafac®1157 was subjected to UV-light induced photolysis. The experimental conditions aimed to simulate Arctic conditions and the deacetylated species was again the primary transformation product of 6:2 FTAB. A 6:2 fluorotelomer sulfonamide was also formed along with a non-identified transformation product. The environmental presence of most of the metabolites and transformation products was qualitatively demonstrated by analysis of soil samples taken in close proximity to an airport fire training facility.     

Americium,plutonium and uranium contamination and speciation in well waters,streams and atomic lakes in the Sarzhal region of the Semipalatinsk Nuclear Test Site,Kazakhstan

New data are reported on the concentrations, isotopic composition and speciation of americium, plutonium and uranium in surface and ground waters in the Sarzhal region of the Semipalatinsk Test Site, and an adjacent area including the settlement of Sarzhal. The data relate to filtered water and suspended particulate from (a) streams originating in the Degelen Mountains, (b) the Tel′kem 1 and Tel′kem 2 atomic craters, and (c) wells on farms located within the study area and at Sarzhal. The measurements show that ²⁴¹Am, ^239,240Pu and ²³⁸U concentrations in well waters within the study area are in the range 0.04–87 mBq dm⁻³, 0.7–99 mBq dm⁻³, and 74–213 mBq dm⁻³, respectively, and for ²⁴¹Am and ^239,240Pu are elevated above the levels expected solely on the basis of global fallout. Concentrations in streams sourced in the Degelen Mountains are similar, while concentrations in the two water-filled atomic craters are somewhat higher. Suspended particulate concentrations in well waters vary considerably, though median values are very low, at 0.01 mBq dm⁻³, 0.08 mBq dm⁻³ and 0.32 mBq dm⁻³ for ²⁴¹Am, ^239,240Pu and ²³⁸U, respectively. The ²³⁵U/²³⁸U isotopic ratio in almost all well and stream waters is slightly elevated above the ‘best estimate’ value for natural uranium worldwide, suggesting that some of the uranium in these waters is of test-site provenance. Redox analysis shows that on average most of the plutonium present in the microfiltered fraction of these waters is in a chemically reduced form (mean 69%; 95% confidence interval 53–85%). In the case of the atomic craters, the proportion is even higher. As expected, all of the americium present appears to be in a reduced form. Calculations suggest that annual committed effective doses to individual adults arising from the daily ingestion of these well waters are in the range 11–42 μSv (mean 21 μSv). Presently, the ground water feeding these wells would not appear to be contaminated with radioactivity from past underground testing in the Degelen Mountains or from the Tel′kem explosions.     

火电厂CO2捕集与封存技术探讨

火电厂CO2减排技术主要包括燃烧前处理、燃烧中减排及燃烧后捕集三类。介绍了IGCC、富氧燃烧、胺吸收法、生物法等CO2捕集与封存技术,分析其存在问题及应用前景。     

膜吸收法净化低浓度甲醛和氨气简

基于膜吸收技术自制双层平板式膜吸收器，搭建净化低浓度甲醛和氨气污染模拟系统，考察不同膜结构参数、进气流量、吸收剂流量等因素对其净化效果的影响。结果表明，聚偏氟乙烯PVDF对低浓度甲醛和氨气的净化效率高于聚四氟乙烯PTFE。对同一材质膜，随着膜孔隙率的增大，甲醛和氨气的净化率呈上升趋势。随着进气流量的增加，甲醛和氨气的净化效率降低；而吸收剂流量对其净化效率影响不大。对于所有实验条件，平均膜孔径为0.22 μm的PVDF 4^#在进气流量u_g=120 L/h时，甲醛和氨气的净化效率最高，分别达94.7%和96.3%。     

钢渣掺量对泡沫混凝土砌块性能的影响

泡沫混凝土是一种环保、节能的保温隔热材料，以其优良的保温性能，受到越来越多研究者的关注。对钢渣的特性进行了分析测试，对钢渣不同掺量对泡沫混凝土砌块特性的影响进行了研究，结果表明，采用添加5％～35％钢渣所制备的钢渣泡沫混凝土砌块，其密度等级为JC／T1062—2007中的B10级，掺人5％、15％钢渣的泡沫混凝土抗压强度达到A3．5等级，掺人25％、35％钢渣的泡沫混凝土抗压强度达到A2．5等级。随着钢渣掺量的增大，抗压强度、抗折强度降低，吸水率增大。在同一钢渣掺量的情况下，泡沫混凝土砌块的抗压强度变化率增加显著，而且随着钢渣的加入量升高而增大。钢渣的加入有利于提高泡沫混凝土砌块的后期抗压强度。     

旋转填料床/柠檬酸盐法吸收-解吸SO2

提出采用旋转填料床结合柠檬酸盐法脱除烟气中SO2的方法,考察了旋转填料床转子转速、液气比、初始柠檬酸根浓度和初始pH值等因素对脱硫效率的影响。结果表明,采用超重力法超重机转子转速为1 000 r/min、液气比为7L/m3、初始柠檬酸根浓度为1.5 mol/L、吸收液的初始pH值为5.0,脱硫效率稳定在99%左右。研究了水蒸气汽提法解吸SO2时初始柠檬酸根浓度、初始pH值、SO2浓度、富液流量和水蒸气流量对解吸效率的影响,得出了影响SO2解吸率的基本规律,并进行了分析。通过实验证明该方法在技术上是可行的,具有良好的应用前景。